How to make cocaine The simple way By J.W Disclaimer: This file was written for educational purposes only, I will not take any responsibility for your use/misuse of this information. If you harm youself or anyone else, its your fault, not mine. Chemicals needed: Limewater Kerosene Sulphuric acid Potassium permanganate Water Ammonium hydroxide Acetone Hydrochloric acid Coca leaves Equipment needed: Heating lamps Fans Basins Muslin cloths Procedure: Cocaine base extraction: The coca leaves are placed into a basin, and are soaked in limewater. Kerosene is added, and it is allowed to sit in this basin for 1-4 days, being agitated each day. Sulphuric acid is added to the mixture, and a precipitate will form, this is called ‘coca paste’. The mixture is filtered, and the liquid is discarded, the paste is allowed to dry. The coca paste is placed into another basin and dilute sulphuric acid is added. Next a potassium permanganate solution is added. This is allowed to stand for 6 or more hours. The solution is filtered and the precipitate is discarded. Ammonium hydroxide is added; this will cause another precipitate to form. The solution is filtered and the liquid is discarded, the precipitate is dried under heat lamps. The resulting powder is called ‘cocaine base’ Cocaine base conversion The cocaine base is dissolved in acetone. Hydrochloric acid is dissolved into more acetone, and the two liquids are poured to together, this is allowed to sit for 3-6 hours. A precipitate will form below the acetone and the entire mix is then poured through cloth to trap the cocaine hydrochloride crystals. The cloth is then wrung dry to remove the last of the acetone. The final drying of the cocaine takes place under heating lamps. Pure cocaine is then compressed into 2.2lbs bricks for shipment to the United States and elsewhere. By Jonathan Wallace